Page 1 of 1

ModMyPi - 7" Touchscreen Case and Stand

Posted: Tue Sep 08, 2015 5:13 pm
by Dave
With the launch of the official Raspberry Pi 7" Touchsreen Display we have designed our very own case and stand!

We hope you like it!

Feel free to comment and make suggestions if you feel we can better this product :)

ModMyPi - 7" Touchscreen Case and Stand

Re: ModMyPi - 7" Touchscreen Case and Stand

Posted: Sat Sep 26, 2015 10:15 am
by hotzeplotz
hi,

can this case be adapted to use longer metal spacers in order to accommodate a Raspberry Pi 2 with a Piface Digital 2 board connected to it, or are there any bits that won't fit together if using longer spacers?

i understand that if this is possible the case may not balance anymore on the stand, but that's not an issue for me as i only need to mount the case against a wall, without stand of course.

Re: ModMyPi - 7" Touchscreen Case and Stand

Posted: Sat Sep 26, 2015 11:13 am
by Jake
You can use longer spacers - it will all still fit together! Longer spacers would simply push that back plate further away so you can accommodate HATs

FYI - The current spacers are M3 F/F x 30mm.

You're correct that it might not balance on the stand correctly if longer spacers are used, but this isn't a problem for you!

-- Jake