ModMyPi - 7" Touchscreen Case and Stand

Check out all our new product launches here
Post Reply
User avatar
Dave
ModMyPi
Posts: 2936
Joined: Wed Jul 22, 2015 11:36 am
Contact:

ModMyPi - 7" Touchscreen Case and Stand

Post by Dave » Tue Sep 08, 2015 5:13 pm

With the launch of the official Raspberry Pi 7" Touchsreen Display we have designed our very own case and stand!

We hope you like it!

Feel free to comment and make suggestions if you feel we can better this product :)

ModMyPi - 7" Touchscreen Case and Stand
Forum Administrator & Technical Support

hotzeplotz
n00b
Posts: 3
Joined: Sat Sep 26, 2015 10:07 am

Re: ModMyPi - 7" Touchscreen Case and Stand

Post by hotzeplotz » Sat Sep 26, 2015 10:15 am

hi,

can this case be adapted to use longer metal spacers in order to accommodate a Raspberry Pi 2 with a Piface Digital 2 board connected to it, or are there any bits that won't fit together if using longer spacers?

i understand that if this is possible the case may not balance anymore on the stand, but that's not an issue for me as i only need to mount the case against a wall, without stand of course.

User avatar
Jake
ModMyPi
Posts: 1456
Joined: Thu Aug 27, 2015 3:57 pm

Re: ModMyPi - 7" Touchscreen Case and Stand

Post by Jake » Sat Sep 26, 2015 11:13 am

You can use longer spacers - it will all still fit together! Longer spacers would simply push that back plate further away so you can accommodate HATs

FYI - The current spacers are M3 F/F x 30mm.

You're correct that it might not balance on the stand correctly if longer spacers are used, but this isn't a problem for you!

-- Jake
Forum Administrator & Technical Support

Post Reply